Dishwasher Standing Water After Cycle?
Start with five checks for the filter area, drain hose, sink drain, air gap, and disposal connection.
Private by design: Your entries stay in this browser and are not submitted to us.
Free searchable directory
Describe the symptom in your own words and find the most relevant guide from our complete troubleshooting library.
All 31 guides remain visible without JavaScript. Search and category filters run only in your browser, require no account, and do not upload what you type.
31 matching guides
Try a shorter symptom such as water, smell, drying, noise, or leak. You can also use the guided symptom checker.
Start with five checks for the filter area, drain hose, sink drain, air gap, and disposal connection.
Trace the next likely causes when cleaning the filter did not restore normal drainage.
Separate normal residual water from a filter-area drainage problem and choose safe next steps.
Check partial drainage, leftover water, filter debris, and sink-side restrictions.
Safely scoop out water, clear the filter area, and decide what to check next.
Work through visible filter, hose, air-gap, and disposal connection checks.
Recognize signs of kinks, buildup, poor routing, backflow, and sink-side restrictions.
Check debris under the cap, sink restrictions, hose routing, and the disposal connection.
Check the knockout plug, hose route, and sink drainage after disposal work.
Investigate overnight backflow, delayed draining, hose routing, and sink-side problems.
Check sink backup, the air gap, hose routing, and disposal connection problems.
Trace sink-side backflow, hose routing, air-gap, and disposal clues.
Check filter sludge, backflow, drain-hose routing, and air-gap blockages.
Work through the filter, standing water, spray arms, seals, and trapped residue.
Remove odor sources and reduce trapped moisture between cycles.
Clean a removable filter and recognize warning signs of a larger wash or drain issue.
Clear blocked nozzles and restore rinse coverage on the upper and lower racks.
Clean the filter, seals, spray arms, drain area, and other odor-prone spots.
Use a repeatable filter, spray-arm, seal, detergent, and rinse-aid routine.
Choose a practical schedule for your household size while preventing odors and buildup.
Check rinse aid, loading, temperature, cycle settings, and vent basics.
Separate removable mineral film from possible glass etching and adjust the wash routine.
Check water hardness, detergent amount, rinse aid, and filter buildup.
Check the upper spray arm, loading pattern, water flow, and filter condition.
Review loading, filter buildup, spray-arm holes, and cycle selection.
Check dispenser blockage, moisture, spray flow, temperature, cycle, and pod placement.
Check blocked door movement, sticky buildup, loading interference, and latch trouble.
Check the gasket, latch alignment, spray-arm position, detergent, and loading.
Look for hard debris, spray-arm interference, and visible filter-area buildup.
Check the shutoff valve, door latch, float, supply hose, and service handoff signs.
Rule out the latch, control lock, delay start, breaker, and safe reset steps.
The finder organizes published guidance; it does not remotely inspect or diagnose the appliance. Read our complete safety guidance.
Common questions